Constant current is a simple form of charging batteries, with the current level set at approximately 10% of the maximum battery rating.Charge times are relatively long with the disadvantage that the battery may overheat if it is over-charged, leading to premature battery replacement.This method is suitable for Ni-MH type of batteries.
In this video we'll show how to design and simulate a voltage charge controller for a battery. i.e. the battery stops charging once it reaches a certain voltage value that corresponds to a particular SOC. The base model for simulation can be found in the link below : https://youtu.be/aSTEfvgKdE8
Do refer the above video for any clarifications of any kind. If you still have any queries, post them down in the comments sections and we shall get back to you at the earliest.
Comments